Crossing Connections
To assist in the selection of the proper fitting for your application, Sasco fittings, many of which have multiple applications, are grouped according to their most common use.
Five Hole Wing Fitting
S536W-HG
Eight Hole Wing Fitting
S537W-HG
Two Hole Angle
S205A-HG
Three Hole Angle
S209A-HG
Z-Shaped Angle
| Catalogue No. | L | |
| S315Z-HG | 3 1/4" | 82.6 mm |
| S313Z-HG | 2 7/16" | 61.9 mm |
| S309Z-HG | 1 5/8" | 41.3 mm |
| S312Z-HG | 1" | 25.4 mm |
| S301Z-HG | 13/16" | 20.6 mm |
Four Hole Angle
S235A-HG
Five Hole Angle
S230A-HG
U Shaped Fitting
| Catalogue No. | L | |
| S425U-HG | 3 1/4" | 82.6 mm |
| S424U-HG | 2 7/16" | 61.9 mm |
| S421U-HG | 1 5/8" | 41.3 mm |
| S420U-HG | 1" | 25.4 mm |
| S419U-HG | 13/16" | 20.6 mm |
Three Hole Angle
S212A-HG
Four Hole Angle
S214A-HG
Five Hole Angle
S216A-HG
| S216A-HG | Left Hand (shown) |
| S215A-HG | Right Hand |
Three Hole Flat Plate
S113P-HG
Three Hole Flat Plate
S111P-HG
Five Hole Cross Plate
S121P-HG
This product comes in the following finishes:
Product Suffix:Hot Dip Galvanized After Fabrication HG
Electroplated Zinc EG
Stainless Steel Type 304 SS4
Stainless Steel Type 316 SS6
Standard Finish is defined by the suffix shown while other finishes are also shown. Many of these other finishes are stocked, however some may require custom manufacturing.
| General Data | (In) | (mm) |
| Hole Diameter | 9/16 | 14.3 |
| Hole Spacing from End | 13/16 | 20.6 |
| Hole Spacing on Centre | 1 7/8 | 47.6 |
| Width | 1 1/2 | 38.1 |
| Thickness | 1/4 | 6.4 |
Dimensions are to outside edge unless otherwise indicated.